Description:
Since I bought a lathe and have started doing some metalwork I have found myself spending a lot of time measuring a piece and then trying to convert the measurement from thousandths of an inch to fractional inches - usually to find a drill bit.
I wrote CaliperTool to help. Enter a decimal inch value and press "calc." CaliperTool will find the closest 1/64" values above and below your measurement and print them along with their respective errors.
It will also do a simple metric conversion and list the measurement in millimeters. And if that weren't enough, if your measurement is reasonably close to a "letter" or "number" drill bit size, it will list the closest of them as well.
Reviews:
***** [Jul 20, 2010] by Handyman Mike
This will bring new life to my old dial caliper. Thanks a bunch.
**** [Jul 20, 2010] by Bombolo
Using metric system is better
**** [Nov 25, 2009] by Ann
Very useful!
***** [Mar 9, 2008] by RG
Good job !
Write a review
|
