Description:
OBD Gauge displays data from your vehicle's diagnostic sensors, reads diagnostic trouble codes, and clears the "check engine" light.
Features:
- Graphs diagnostic sensor data
- Reads DTCs (diagnostic trouble codes)
- Clears the "check engine" light
- 0-100 km/h (or 0-60 mph) performance timer
- Records sensor data for display on PC
Requirements:
- Palm with serial port
- Serial HotSync cable
- OBD-II Interface: ScanTool.net ElmScan ISO, VPW, or PWM
- Multiplex Engineering T16-006 or T16-003
Reviews:
**** [Jul 7, 2005] by bigjoepos
Just installed this on my M-100 with only 2 mb of memory. Connected this to my car using the multiplex engineering interface. Version 1.9 did not work on this old palm so I came to this website and downloaded 1.8 and it worked just fine. The interace needs to be configured in the options section of the software. Once this was done the readouts started immediately. I did not have any DTC codes on this car and will try on another later that I know has failed NJ inspection because there was a pending code without the MIL light on. More to come....
* [Mar 19, 2005] by PIERRE
It never gets off the ground ...it's always initializing and absolutley does nothing on my m515
***** [May 19, 2004] by Paul
Hoping to get it to work on my treo 600. seems like a handy thing to have!
Write a review
|
